ZIEHL-ABEGG S-ET Series Operating Instructions Manual
            | |
1 General notesCompliance with the following instructions is mandatory to ensure the functionality andsafety of the product. If the following instructions given especially but not limited forgeneral safety, transport, storage, mounting, operating conditions, start-up, mainte-nance, repair, cleaning and disposal / recycling are not observed, the product may notoperate safely and may cause a hazard to the life and limb of users and third parties.Deviations from the following requirements may therefore lead both to the loss of thestatutory material defect liability rights and to the liability of the buyer for the product thathas become unsafe due to the deviation from the specifications.1.1 Structure of the operating instructionsBefore installation and start-up, read this manual carefully to ensure correct use!We emphasize that these operating instructions apply to specific units only, and are inno way valid for the complete system!Use these operating instructions to work safely with and on the device. They containsafety instructions that must be complied with as well as information that is required forfailure-free operation of the device.Keep these operating instructions together with the device. It must be ensured that allpersons that are to work on the device can refer to the operating instructions at any time.1.2 Exclusion of liabilityTo allow for future developments, construction methods and technical data given aresubject to alteration. We do not accept any liability for possible errors or omissions in theinformation contained in data, illustrations or drawings provided.We accept no liability for damage caused by misuse, incorrect use, improper use or as aconsequence of unauthorized repairs or modifications.2 Safety instructions• Installation, electrical connection and commissioning to be carried out by trainedservice personnel only. The specifications of the manufacturer or supplier, andinstructions relating to the equipment, should be rigidly adhered to. Failure to complywith these conditions will invalidate the guarantee on our controllers and accessories!• The 5 electrical safety rules must be observed!• It is strictly forbidden for work to be carried out on any components while they areconnected to live voltage. The open equipment is protected to IP00. It is possible tocome into direct contact with dangerous voltages!• The safe isolation from the supply must be checked using a two-pole voltagedetector.• Cover neighbouring electrical equipment during installation work.• During operation, the device must be closed or installed in a control cabinet. Fusesmay only be replaced by new ones and must not be repaired or bypassed. The datafor the maximum line fuse are to be considered absolutely (see Technical data). Useonly fuses specified in schematic diagrams.• Never clean electrical equipment with water or similar liquids.Operating Instructions S-ET... / S-DT... General notesL-BAL-E058-GB 1931 Index 002 Part.-No.3/12 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine