(1) Post the mounting template on thewall.Drill the holes according tothe marks on the template (holesVersion: V1.0 Date: April, 2011(2) Remove the screws on the bottom (3) Take away the back plate.(5) Tighten the screws on the bottom,plate on the wall according to the(4) Fix the plastic pad and the backRS485 TCP/IPLock Sensor①③AlarmRS485 Converter②NC LOCK-+DC12V+NC LOCK+-NO LOCK--FR 107+-FR 107+12V +12V+12V+12VGND GNDGNDGNDGND GNDGNDGNDGNDSEN SENSENSENSENBUT BUTBUTBUTBUTBELL+ BELL+BELL+BELL+BELL+BELL- BELL-BELL-BELL-BELL-NO LOCK-+DC12V+-+-FR 107-+DC12V+--+DC power-+DC12V-+DC power+- FR 107+DC12V-+ GND+12VExit Button⑤External Reader④Door BellDoor Bell%%BUTTONEXITEXITBUTTON⑦⑥-+ AlarmAlarm PowerExit ButtonDoor Sensorfor screws and wiring).of device.Access Control System Function(1) If a registered user verified, the device will export the signalto unlock the door.(3) If only the d llegal removed, the device willevice being i ly(4) isExternal card reader supported.(5) is it isExternal exit button supported, convenient to open the(2) Door sensor will detect the on-off state If the door is unexpectedopened or improperly closed, the alarm signal (digital value) will betriggered.export alarm signal.door inside.(7) Supports , modes withRS485 TCP/IP to connect PC. One PC canmanage multiple devices.(6) External door bell is supported.①: ‘‘I’: device output current, ‘ ’: lock voltage, ’: lock currentULOCK ILOCK(1) The system supports NO LOCK and NC LOCK. For example the NO LOCK (normally open at power on) is connectedwith ’NO’ and terminals,’COM’ and ’COM’ terminalsand the NC LOCK is connected with ‘NC’ .(equipped in the package) to prevent the self-inductance EMF affect the system, do not reverse the polarities.3.Lock Connection! Warning: No operating with power on(1) Share power with the lock:A. ULOCK=12V, I-ILOCK>1A…… ①B. The lock is near to the device.Device share power with the lock:Device does not share power with the lock:A. =12V I- ≤1A;ULOCK ILOCKB ≠12V;. ULOCKC. The lock is far apart from the device.Voltage output ≤ DC 12V for Alarm4. Other Parts Connection: 5. Power Connection:Input DC 12V, 500mA (50mA standby)Positive is connected with ‘+12V’, negative is connectedwith ’GND’ (do not reverse the polarities).(2) Does not share power with the lock:2. Structure and FunctionF17 Installation Guide1. Equipment Installation(2) When the Electrical Lock is connected to the Access Control System, you need to parallel one FR107 diodeNC1 NC1NC1NC1NC1NO1 NO1NO1NO1NO1COM1 COM1COM1COM1COM1NO2 NO2NO2NO2NO2COM2 COM2COM2COM2COM2fix the device to the back plate.Wiring HoleIn st ru ct io n fo r th e Mo un ti ng P ap erBe fo re t he d ev ic e is f as te ne d, p le as est ic k th e pa pe r to t he p la ce w he re y ouwa nt t o in st al l it , th en m ak e ho le s an dla y ca bl es a cc or di ng t o th e mo un ti ngpa pe r.F17 Mounting Paper(only for your reference)Fixing HoleFixing HoleFixing Hole10111213mounting paper.