Zanotti RCV series Use And Maintenance Instructions
Also see for RCV series: Wiring diagram
                                                                            | |
18143 DESCRIPTION OF THE UNITThe RCV series includes air-cooled or water-cooled (optional)units built on the basis of the single-blockprinciple. They consist of:234 OPERATION1. a condensing unit placed outside the cold room;2. an evaporator placed in an insulated box and installed outside thecold room;3. an electric control panel placed on the condensing unit;4. a wall-mounted remote control panel.RCV single blocks are compression units where cold is produced by vaporizing a liquid refrigerant (HFCtype) at low pressure in a heat exchanger (evaporator). The resulting vapour is brought again into theliquid state by mechanical compression at a higher pressure, followed by cooling in another heat exchanger(condenser).The compressor is hermetic, with reciprocating motion, supplied with single-phase or three-phase power.5 HANDLINGThe unit can be handled by lifting and transport means.W AR NI NGM ak e sure that no one is in transit in the operating area of the lifting/ transportm eans to prevent any possible accidents to people.I f the unit is in a w ooden case or crate, sling the packing properly beforehandling it.Lifting speed shall be such as not to m ak e the pack ed unit oscillate dangerouslyand possibly fall. |
manualsdatabase
Your AI-powered manual search engine