Zanussi ZCE560 User Manual

Also see for ZCE560: Manual

Contents

Zanussi ZCE560 User Manual Manual pdf 19 page image

Problem Possible solutionThe grill, ovens and timer do not work.The grill and top oven work but the main oven does not.The timer does not work.The oven is not cooking evenly.The indicator neons are not working correctly.The oven fan is noisy.The oven temperature is too high or too low.•••••••••••Check that the appliance has been wired in to theappliance supply and is switched on at the wall.Check that the main appliance fuse is working.If you have checked the above: Allow the applianceto cool for a couple of hours. The appliance shouldnow be working normally.Check that the time of day has been set on the clock.Check that the instructions for the operation of thetimer are being closely followed.Check that the appliance is correctly installed andis level.Check that the recommended temperatures andshelf positions are being used.Check that you have selected only the function yourequire. Ensure all other controls are in the off position.Check that the oven is level.Check that the shelves and bakeware are not vibratingin contact with the oven back panel.mCheck that the recommended temperatures andshelf positions are being used. Be prepared to adjustthe temperature up or down to achieve theresults you want.InstallationInstallation instructionsThis appliance must be earthed.• If your appliance has been damaged in transit,contact your supplier immediately. Do not attemptto install it.• Your appliance left the factory fully packaged toprotect it from damage. If it is delivered withoutpackaging and damage has occurred, themanufacturer cannot accept responsibility. Contactyour supplier for advice.• Once the packaging has been removed theappliance should only be moved by hand. Do notuse a sack barrow or any other aid to lift theappliance as damage may occur. Do not carry theappliances at the doorhandle.• To move the appliance, open the oven door and liftthe appliance by holding inside the top of thecompartment.• This is a type X appliance, which means it isfreestanding and can be fitted with cabinets on oneor both sides.• Sidewalls, which are above hob level, should beprotected by heat resistant non-combustiblematerial and must not be nearer than 40mm to thehob side.• A nominal air gap of 5mm at either side of theappliance is required to enable the appliance to bemoved into position.• Always ensure an air gap is maintained at hotplatelevel. Tiles or other forms of deep wall coveringshould not obscure this gap.• Overhanging surfaces or a cooker hood should bea minimum of 685mm above the hob.• It is important to ensure that the appliance is levelafter installation. Levelling feet are fitted to theappliance to accommodate uneven floors.Adjustment of levelling feetThe cooker stands on 4 levelling feet. It is required toconfirm the appliance is correctly levelled before! WARNING!19