Zanussi ZCG 6600 Operating And Installation Instructions

10. CHECKING THE MAIN OVENCONTROLSTO SET THE TIME OF DAY (see Fig.5)1. Turn on the electricity supply and ensure that thethermostat is in the off position.1a. Before setting timer read important note below.2. Rotate the left hand clock knob to manual andback to the clock ' ' position.3. Set the time of day by rotating the right handknob. Note that it is a 24 hour clock.4. Rotate the left hand clock knob back to themanual position.NOTE: When setting the time of day with the selector knob in the clock ' ' position only, this will activatethe timer for seven seconds after selection. This means that when setting the time of day in this function thetime can only be set by using the right hand knob within a seven second period.After seven seconds have elapsed from when the correct time of day has been set, the timer ceases tobe active and subsequent operation of the right hand knob will not change the time setting.When the right hand knob is turned anti-clockwise after the seven second delay period, a choice ofthree audible signals are available. To select the choice of signal required rotate knob anti-clockwise andrelease. Repeat procedure to choose desired signal.11. CHECKING THE MAIN OVEN1. Set the clock as described above, the clock is now ready for manual operation.2. Turn the main oven thermostat to Mk.9 and check that there is sparking from the ignition system. Thisshould continue until the oven burner is alight.3. When the oven burner lights up the sparking should cease, there should be a low gas rate at first to theoven burner which is the flame supervision device (F.S.D.) by pass rate.4. When the F.S.D. phial has heated up it opens the F.S.D. valve and the main gas stream flows to theburner.5. Set the oven thermostat to Mk.2, close the oven door and check that after about 10 minutes the flamehas reduced in size.6. Turn off the thermostat and check that the oven flames go out.12. AUTOMATIC OPERATIONHaving set the clock up as described above, turn the left hand knob to the 'cook time' position and set theright hand knob to show a cooking time of two minutes (0.02).Turn the left hand knob to the 'end time' position; the time shown on the display is now the time of day withtwo minutes added on. Rotate the right hand knob to add two minutes to this time to give a two minute delay.Turn the left hand knob to the 'automatic' position to complete the programming sequence, the clock nowshows the time of day again with 'auto' glowing continuously.Turn the oven thermostat on and two minutes after setting, the oven burner should commence its lightingsequence.Two minutes after the lighting sequence has started the timer should cut off the gas supply to the oven burnerand the audible signal should sound. The signal is continuous it may be switched off at any time by rotatingthe left hand knob.Return timer to manual by rotating the left hand knob to the 'manual' position.47Fig.5