General informationMoving your cookerYou may damage some soft or badly fitted floor coverings when youmove the cooker. The floor covering under the cooker should besecurely fixed so it does not ruck up when you move the cooker acrossit. Alternatively you could remove the floor covering.To move the cooker open the second oven door. Raise the cookeroff its front feet by lifting it from inside the oven. Pull the cooker forward.When you replace the cooker push it back to the stop and make surethere is the same gap at each rear corner.Connecting to the electricity supplyThe plug supplied with the cooker can be fitted directly to a suitablethree pin earthed socket.If you have to change the fuse replace it with a 3 amp fuse which hasbeen ASTA approved to BS 1362.Do not use the plug until you have put the fuse cover back on. If thefuse cover is lost you can get a replacement from an electrical retailer.The correct replacement can be identified by marking or colour coding.Z C G 7 7 0 0 X29General informationFor your safetyDo not try to disconnect the cooker from the gas supply if thesupply pipe does not have a bayonet connection, as described inthe installation instructions. If this is the case contact the personwho installed the cooker.For your safetyThis cooker must be earthed and protected by a 3 amp fuse.For your safetyDo not block any of the cooker vents.Never line any part of the cooker with aluminium foil.Don't let items which can catch fire or electric mains leads such askettle flexes trail over any part of the cooker.