Zanussi ZCM 6600 Instruction Booklet

10“End of cooking” functionWith this function, you can set the oven to switch off automatically when aprogrammed end of cooking time is over. Place food in the oven, select a cookingfunction and adjust the cooking temperature. Press button repeatedly to selectthe “End of cooking” function. The relevant pilot lamp will start flashing. Then,proceed as follows:To set the End of cooking time:1. Press button or .2. After the setting is carried out, wait for 5 seconds: the “End of cooking” pilotlamp will come on and the display will revert to the time of day.3. When cooking time is over, the oven will be switched off automatically and anacoustic alarm will be heard, and the pilot lamp will start flashing. Turn theoven function and the thermostat control knob to zero.To switch off the acoustic alarm, press any button. NOTE: turning the acousticalarm off will reset the oven to manual, and if the oven function and thethermostat knobs are not set to zero the oven will start to heat again.To cancel the End of cooking time:1. Press button repeatedly to select the “End of cooking” function. Therelevant pilot lamp will flash and the display will show the programmedEnd of cooking time.2. Press button until the display shows the current time of day. Theprogrammer will beep and the pilot lamp will go out.“Cooking duration” and “End of cookingtime” combinedThe functions “Cooking duration” and “End of cooking time” can be usedsimultaneously to set the oven to switch on and off automatically at a later time.1. With the “Cooking duration” function (carry out the cooking duration settingas described in the relevant chapter) set the duration time. Then, press button: the display will show the programmed setting.2. With the “End of cooking time” function (carry out the End of cookingsetting as described in the relevant chapter) set the end of cooking time.The relevant pilot lamps will come on and the display will show the time ofday. The oven will switch on and off according to the set programmes.“Minute minder” functionThe minute minder alarm will sound at the end of a timed period, but THE OVENWILL REMAIN ON, if it is in use.To set the minute minder:1. Press button repeatedly to select the “Minute minder” function. The relevantpilot lamp will start flashing.2. Then, press button or (maximum: 2 hours, 30 minutes).3. After the setting is carried out, wait for 5 seconds: the “Minute minder” pilotlamp will come on.4. At the end of the timed period, the pilot lamp will start flashing and an acousticalarm will be heard. To switch off the acoustic alarm, press any button.To cancel the minute minder:1. Press button repeatedly to select the “Minute minder” function. The relevantpilot lamp will flash and the display will show the remaining time.2. Press button until the display shows “0:00”. After 5 seconds the pilotlamp will go out and the display will revert to the time of day.How to switch off the display1. Press two or three programmer push buttons simoultaneously and keepthem pressed for about 5 seconds. The display will switch off.2. To switch on the display, press any button.The display can be switched off only if no other functions have beenset.