Zanussi ZDI 100 User Manual
                        | |
Contents
| 
9Setting the water softener electronically (see table)Release the button. The END indicator light willflash. The number of flashes corresponds to currentlevel set.The END indicator light might flash 5 times, forexample. The flashing is repeated every 5 seconds.To change the level, press the start/cancel button.Each time the button is pressed the level increases.(Level 1 follows level 10).The END indicator light indicates the new setting.To memorise the operation, turn the programmeselector dial to position off.Press and hold the start/cancel button and turn theprogramme selector dial clockwise till the firstprogramme.Keep the button pressed until the programme On/offindicator light and the start/cancel indicator lightstart flashing.The water softener is factory set at position 5.The dishwasher must be switched offFilling with dishwasher saltUnscrew the cap. Only before filling withsalt for the first time,fill the salt containerwith waterUsing the funnelprovided, pour in thesalt until the container isfull.CAUTION!Use only special salt suitable for dishwashers156998720en.qxp 1/31/2007 4:22 PM Page 9 |
Related manuals for Zanussi ZDI 100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine