Zanussi ZDS 699 Instruction Booklet

Also see for ZDS 699: Instruction booklet

8b. Setting and starting theprogramme with "delay start"Once a programme and eventual optionshave been setted for the "delay start"proceed as follows:Press the "delay start" pushbutton, in thedigital display will appear "h0". Press thebutton again to select the number of hoursby which you wish to delay the programmestart, up to a maximum of 12 hours.The delay start will not modify the settingsmade previously .To set to zero the time setting press the"delay start" pushbutton until "h0" appearsin the digital display.Press the "programme start" pushbutton, inthe digital display the time to go before thestart of the programme will be indicatedwith step of 1 hour.You are informed of the operating of thecountdown by a flashing "h" in the digitaldisplay.Once the countdown has ended theprogramme will start.9. At the end of the washingprogrammeThe dishwasher will automatically stop andan intermittent audible signal informs youthat the programme has ended.3 flashing horizontal lines appear in thedigital display and all the indicator lightsturn off.To return in setting mode press any of thepushbuttons or switch off and then switchon the dishwasher.The dishwasher can now be opened.If the dishwasher door remains closed,the turbo drying will go on performingfor a few minutes, this will allow afurther dehumidification.10. To cancel a programme inprogressPress the "programme start" pushbutton for5 seconds to cancel the setting of theprogramme under way.All the indicator lights will turn off and 3horizontal lines will appear in the digitaldisplay. After 3 seconds the dishwasher willreturn in setting mode.It is now possible to select a new washingprogramme.When the wash programme hasfinished, it is recommended that thedishwasher is unplugged and the watertap turned off.In general it is not advisable to open thedoor while the machine is working;if thedoor is opened however, a safety deviceensures that the machine stops.CautionDo not open the door during the hotphase: this may cause hot waterescape.Care must be taken if the door isopened during the hot phase orimmediately after a programme hasfinished, as steam may escape.45 POS27GB