Zanussi ZFC21400WA User Manual

Also see for ZFC21400WA: User manual User manual

• WARNING: Do not damage the refrigerant circuit.• WARNING: Do not use electrical appliances inside the foodstorage compartments of the appliance, unless they are of thetype recommended by the manufacturer.• Do not use water spray and steam to clean the appliance.• Clean the appliance with a moist soft cloth. Only use neutraldetergents. Do not use abrasive products, abrasive cleaningpads, solvents or metal objects.• Do not store explosive substances such as aerosol cans with aflammable propellant in this appliance.• If the supply cord is damaged, it must be replaced by themanufacturer, its Authorised Service Centre or similarlyqualified persons in order to avoid a hazard.SAFETY INSTRUCTIONSINSTALLATIONWARNING! Only a qualified personmust install this appliance.• Remove all the packaging.• Do not install or use a damaged appliance.• Follow the installation instructions supplied withthe appliance.• Always take care when moving the appliance asit is heavy. Always use safety gloves andenclosed footwear.• Make sure the air can circulate around theappliance.• At first installation or after reversing the doorwait at least 4 hours before connecting theappliance to the power supply. This is to allowthe oil to flow back in the compressor.• Before carrying out any operations on theappliance (e.g. reversing the door), remove theplug from the power socket.• Do not install the appliance close to radiators orcookers, ovens or hobs.• Do not expose the appliance to the rain.• Do not install the appliance where there is directsunlight.• Do not install this appliance in areas that are toohumid or too cold.• When you move the appliance, lift it by the frontedge to avoid scratching the floor.ELECTRICAL CONNECTIONWARNING! Risk of fire and electricshock.WARNING! When positioning theappliance, ensure the supply cord isnot trapped or damaged.WARNING! Do not use multi-plugadapters and extension cables.• The appliance must be earthed.• Make sure that the parameters on the ratingplate are compatible with the electrical ratingsof the mains power supply.• Always use a correctly installed shockproofsocket.• Make sure not to cause damage to the electricalcomponents (e.g. mains plug, mains cable,compressor). Contact the Authorised ServiceCentre or an electrician to change the electricalcomponents.• The mains cable must stay below the level of themains plug.• Connect the mains plug to the mains socketonly at the end of the installation. Make sure thatthere is access to the mains plug after theinstallation.• Do not pull the mains cable to disconnect theappliance. Always pull the mains plug.14