Problem Possible cause SolutionThere is no voltage in themains socket.Connect to a different electri-cal mains socket. Contact aqualified electrician.The appliance is noisy. The appliance is not supportedproperly.Check if the appliance standsstable.Audible or visual alarm is on. The cabinet has been recentlyswitched on or the temperaturein the appliance is too high.Refer to "High TemperatureAlarm" and if the problem stilloccurs contact the nearest Au-thorized Service Centre.Power indicator light is flash-ing.An error has occurred in meas-uring the temperature or theappliance is not working prop-erly.Contact the nearest Author-ized Service Centre.The lid doesn't close complete-ly.Food packages are blockingthe lid.Arrange the packages in theright way, see the sticker in theappliance.There is excessive frost. Eliminate excess frost.The lid is difficult to open. The lid gaskets are dirty orsticky.Clean the lid gaskets.The valve is blocked. Check the valve.The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".The compressor operates con-tinually.Temperature is set incorrectly. Refer to "Operation" chapter.Large quantities of food to befrozen were put in at the sametime.Wait some hours and thencheck the temperature again.The room temperature is toohigh.Refer to climate class chart onthe rating plate.Food placed in the appliancewas too warm.Allow food to cool to roomtemperature before storing.The lid is not closed properly. Check if the lid closes well andthe gaskets are undamagedand clean.There is too much frost andice.The lid is not closed correctlyor the gasket is deformed/dirty.Refer to "Closing the door".The water drainage plug is notcorrectly positioned.Position the water drainageplug in the correct way.Temperature is set incorrectly. Refer to "Operation" chapter.The temperature in the appli-ance is too low/too high.The temperature regulator isnot set correctly.Set a higher/lower tempera-ture.19