Zanussi ZFT11101 User Manual

10 mm to allow the door to open enough sothat the shelves can be removed.Warning!min.100 mm15 mm 15 mmIt must be possible to disconnect the appliancefrom the mains power supply; the plug musttherefore be easily accessible after installation.Door reversibilityImportant! To carry out the followingoperations, we suggest that this be made withanother person that will keep a firm hold on thedoors of the appliance during the operations.To change the opening direction of the door, dothese steps:1. Remove the plugfrom the power socket.2. Tilt back the appli-ance carefully so thatthe compressor can-not touch the floor.3. Unscrew the leftfoot.4. Remove the lowerdoor hinge by un-screwing the 2 retain-ing screws.5. Remove the hingepin from the bottom ofthe door.6. Slot the hinge pininto the hole in thehinge plate.7. Take the door off.8. Refit the upperhinge pin into the op-posite location.9. Fit the door in placeon the hinge pin.10. Slot the hinge pininto the hole in thehinge plate and relo-cate the hinge assem-bly to the opposite lo-cation and refit usingthe retaining screws.11. Refit the bottomhinge plate assemblyon the opposite side,taking care that theedge of the door isparallel with the side ofthe cabinet.12. Remove and installthe handle (if foreseen)on the opposite side.13. Reposition, levelthe appliance, wait forat least four hours andthen connect it to thepower socket.Do a final check to make sure that:• All screws are tightened.• The door opens and closes correctly.If the ambient temperature is cold (i.e. in Win-ter), the gasket may not fit perfectly to the cabi-net. In that case, wait for the natural fitting of thegasket.In case you do not want to carry out the abovementioned operations, contact the nearest AfterSales Service Force. The After Sales Servicespecialist will carry out the reversibility of thedoors at your cost.Electrical connectionBefore plugging in, ensure that the voltage andfrequency shown on the rating plate correspondto your domestic power supply.The appliance must be earthed. The power sup-ply cable plug is provided with a contact for thispurpose. If the domestic power supply socket isnot earthed, connect the appliance to a sepa-21www.zanussi.com