• It is advisable to wait at least four hours be-fore connecting the appliance to allow theoil to flow back in the compressor.• Adequate air circulation should be aroundthe appliance, lacking this leads to over-heating. To achieve sufficient ventilation fol-low the instructions relevant to installation.• Wherever possible the back of the productshould be against a wall to avoid touchingor catching warm parts (compressor, con-denser) to prevent possible burn.• The appliance must not be located close toradiators or cookers.• Make sure that the mains plug is accessibleafter the installation of the appliance.• Connect to potable water supply only (If awater connection is foreseen).Service• Any electrical work required to do the serv-icing of the appliance should be carried outby a qualified electrician or competent per-son.• This product must be serviced by an author-ized Service Centre, and only genuine spareparts must be used.Environment ProtectionThis appliance does not contain gasseswhich could damage the ozone layer, ineither its refrigerant circuit or insulation materi-als. The appliance shall not be discarded to-gether with the urban refuse and rubbish. Theinsulation foam contains flammable gases: theappliance shall be disposed according to theapplicable regulations to obtain from your localauthorities. Avoid damaging the cooling unit,especially at the rear near the heat exchanger.The materials used on this appliance markedby the symbol are recyclable.OperationSwitching onInsert the plug into the wall socket.Turn the Temperature Regulator to the FullLoaded position and let the appliance run atleast 4 hours to allow the correct temperatureto be reached before placing food inside.Adjust the Temperature Regulator accordingto the quantity of the stored foods.CBAA Temperature RegulatorB Half Loaded positionC Full Loaded positionSwitching offTo turn off the appliance, turn the TemperatureRegulator to the “OFF” position.Temperature regulationThe temperature within the appliance is con-trolled by the Temperature Regulator situatedon the side of the appliance.To operate the appliance, proceed as follows:• turn the Temperature Regulator toward low-er settings to obtain the minimum coldness.• turn the Temperature Regulator towardhigher settings to obtain the maximum cold-ness.In case of freezing less food volumes, theHalf Loaded setting is the most suitable.In case of freezing much food volumes, the FullLoaded setting is the most suitable.15www.zanussi.com