Zanussi ZGF 642 CTN Instruction Booklet

Contents

Zanussi ZGF 642 CTN Instruction Booklet Manual pdf 9 page image

9Important safety requirements650 mm400 mm400 mm100 mm50 mm50 mm55 mm600 mm700 mm400 mm100 mm400 mm50 mm55 mm50 mmICLEARANCES REQUIREDWHEN FITTING THE HOBWITHOUT A COOKER HOOD ABOVECLEARANCES REQUIREDWHEN FITTING THE HOBWITH A COOKER HOOD ABOVEFO 0813FO 0812700 mmThis hob must be installed in accordance with the GasSafety (Installation and Use) Regulations (Current Edition)and the IEE Wiring Regulations (Current Edition).For appliances installed in the Republic of Ireland pleaserefer to NSAI- Domestic Gas Installation I.S. 813 CurrentEditions and the ETCI Rules for Electrical Installations.Provision for ventilationDetailed recommendations are contained in the followingBritish Standards Codes Of Practice: B.S. 6172/ B.S.5440, Part 2 and B.S. 6891 Current Editions.The hob should not be installed in a bed sitting roomwith a volume of less than 20 m 3 . If it is installed in aroom of volume less than 5 m 3 an air vent of effectivearea of 110 cm 2 is required. If it is installed in a room ofvolume between 5 m 3 and 10 m 3 an air vent of effectivearea of 50 cm 2 is required, while if the volume exceeds11 m 3 no air vent is required.However, if the room has a door which opens directly tothe outside no air vent is required even if the volume isbetween 5 m 3 and 11 m 3.If there are other fuel burning appliances in the sameroom, B.S. 5440 Part 2 Current Edition, should beconsulted to determine the requisite air ventrequirements.For appliances installed in the Republic of Ireland pleaserefer to the NSAI- Domestic Gas Installation I.S. 813Current Editions Table Four.LocationThe hob may be located in a kitchen, a kitchen/diner orbed sitting room, but not in a bathroom, shower room orgarage.Before making the cut out in the worktop ensure thatthere is a minimum distance of 55 mm between the rearedge of the hob and the wall.A minimum distance of 100 mm must be left betweenthe side edges of the hob and any adjacent cabinets orwalls.The minimum distance combustible material can be fittedabove the hob in line with the edges of the hob is 400mm. If it is fitted below 400 mm a space of 50 mm mustbe allowed from the edges of the hob.The minimum distance combustible material can be fitteddirectly above the hob is 700 mm.For appliances installed in the Republic of Ireland pleaserefer to NSAI- Domestic Gas Installation I.S 813 CurrentEdition Section 7- Permitted Locations of Appliance.