Zanussi ZGL 62 ITX Instruction Booklet

Contents

11FO 0763 FO 0764 FO 10132 3FO 0199aFitting the Hob into the worktop)Carry out the building in of the hob as follows:• put the seals supplied with the hob, on theedges of the cut out taking care that the sealsmeet without overlapping;• place the hob in the cut out, taking care that itis centred;• fix the hob with the relevant fixing clamps andscrews, as shown in the diagram. When thescrews have been tightened, the excess sealcan be removed.The edge of the hob forms a double seal which preventsthe ingress of liquids.Dimensions are given in mm.Building InBuilding over a cupboard ordrawerIf the hob is to be installed above a cupboard or drawer itwill be necessary to fit a heat resistant board below thebase of the hob on the underside of the work surface.Building over a kitchen unit withdoorProper arrangements must be taken in designing thefurniture unit, in order to avoid any contact with the bottomof the hob which can be heated when it is operated. Therecommended solution is shown in diagram 3.The panel fitted under the hob ("a") should be easilyremovable to allow easy access if technical assistanceis needed. The space behind the kitchen unit ("b") canbe used for connections.SealIt is also recommended to carry out the electricalconnection to the hob as shown in diagrams 1 and 2.ON/OFF SWITCHFLEXOUTLETON/OFF SWITCHFLEXOUTLET1