7Electronic Programmer1. Push button for selecting a function2. Decreasing control button “ ”3. Increasing control button “ ”4. Display5. “Cooking Duration” pilot lamp6. “End of cooking” pilot lamp7. “Minute minder” pilot lamp8. “Time of day” pilot lampThe oven will only work if the time of day has been set.However, the oven can also be operated without any programme.Setting the time of dayWhen the power supply is switched on, or after a power failure, the “Time ofday” pilot lamp will flash on the display.To set the correct time of day:1. Press button “ ” or “ ”.2. After the setting is carried out, wait for 5 seconds: the “Time of day” pilotlamp will go out and the display will show the set time. The applianceis ready for use.To reset the correct time of day:1. Press button repeatedly to select the “Time of day” function. Therelevant pilot lamp will start flashing. Then proceed as described above.The time of day can only be reset if no automatic function (cook durationor end of cooking ) has been set.“Cooking Duration” functionThis function allows the oven to automatically switch off at the end of aprogrammed cooking duration time. Place food in the oven, select a cookingfunction and adjust the cooking temperature. Press button repeatedly toselect the “Cooking Duration” function. The relevant pilot lamp will startflashing. Then, proceed as follows:To set the duration time:1. Press button “ ” or “ ”.2. After the setting is carried out, wait for 5 seconds: the "Cooking Duration"pilot lamp will come on and the display will revert to the time of day.3. When cooking time is over, the oven will be switched off automaticallyand an acoustic alarm will be heard, while the pilot lamp will start flashing.Turn the oven function and the thermostat control knob to zero.To switch off the acoustic alarm, press any button.NOTE: turning the acoustic alarm off will reset the oven to manual, andif the oven function and the thermostat knobs are not set to zero theoven will start to heat again.To cancel the duration time:1. Press button repeatedly to select the “Cooking Duration” function.The relevant pilot lamp will flash and the display will show the remainingcooking time.2. Press button “ ” until the display shows “0:00”. After 5 seconds thepilot lamp will go out and the display will revert to the time of day.4512 3678