Zanussi ZT 132-3 Instructions For Use Manual

Contents

Something not WorkingProblems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions:Level properly the appliances if it is not well levelled.Weight surpasses the storage limit of the door shelf so spread weight more evenly ortake some products out.Readjust the door if it is not properly aligned.Set a lower temperature.Distribute the food products to allow cold air to circulate around them.Make sure that the door is completely closed and that the insulating strip is completeand clean.The temperature where the cabinet is placed is above normal room temperature.Set a warmer temperature.Turn the thermostat knob to a lower numberThe temperature where the cabinet is placed is above normal room temperature.Check that the ventilation is sufficient and that the ventilation openings are unobstructed.The cause could be the introduction of large quantities of food and/or frequentopening/closing of the door.Sometimes this is normal. Temperature control may cause clicking sounds when thesystem is connected or disconnected.The injected cooling gas may produce a gurgling sound while passing through the tubes.The motor may cause a humming noise and/or slight bumping.The insulation material used has a tendency to slighly increase noise levels, how ever itallows for much better insulation and a lower energy consumption,You may occasionally hear the fans working. This is nothing to worry about. The fansare simply helping the air to circulate more effectively.Door do not closeIt is too warm inside the refrigeratorIt is too cold inside the refrigerator.The compressor works continuously.NoisesSYMPTOM SOLUTIONCustomer service andspare partsIf you cannot find the remedy for a malfunction in these operatinginstructions, please contact your dealer or our customer servicedepartment and consult the Guarantee card.Selective ordering of replacement parts can save unnecessarytravel and costs.For this reason always provide the following appliance information:- Model Name- Model Number (PNC)- Serial Number (S-No.)This information can be found on the rating plate inside thecabenit on the left hand wall. We recommend that you enter thisinformation here, so that it is handy if needed.Technical specificationsThe technical data is indicated in the rating plate on the left sideinside the appliance.Height 850 mmWidth 495 mmDepth 600 mmInstallationTake utmost care when handling your appliance so as notto cause any damages to the cooling unit with consequentpossible fluid leakages.• During normal operation, the condenser and compressor at theback of the appliance heat up considerably. Always ensure thatthere is adequate ventilation as a failure to do this will result incomponent failure and possible food loss. See installationinstructions.• Important: if the supply cord is damaged, it must be replaced bya special cord or assembly available from the manufacturer or itsservice agent.Positioning• Unpack the cabinet and check that it is in good condition andfree of any transport damage.• Place the refrigerator away from direct sunlight and heatsources.• Maintain recommended ventilation.• For safety reasons, minimum ventilation must be as shown in thefigure.Appliance positioned under overhanging kitchen wall units (seeFig.-A). Appliance positioned without overhanging kitchen units(see Fig.-B).Attention: keep ventilation openings clear of obstruction.• Two adjustable feet at the cabinet base allow accurate levellingof the appliance. 100 mm10 mm10 mmA BNP0088

/ 6

Related manuals for Zanussi ZT 132-3