Zanussi ZV 50 Instruction Book

Also see for FB 50 R: Instruction book

21When the refrigeratoris not in useIn case the appliance will not be used for a long timefollow these steps:Break the circuit of the appliance.Remove foods from the refrigerator.Defrost and clean it as written before.Leave the door open to avoid a build up of air inside.Trouble shootingDuring operation of the appliance some smaller butannoying trouble can often occur, which does notrequire calling a technician out. In the following chartinformation is given about them to avoid unnecessarycharges on service.We draw your attention that operation of appliance goeswith certain sounds (compressor- and circulatingsound). This is not trouble, but means normaloperation.We draw it to your attention again that theappliance operates discontinuously, so thestopping of compressor does not mean being no-current. That is why you must not touch the electricalparts of the appliance before breaking the circuit.ProblemThe appliance does notcool sufficientlyThe appliance cools toohardThe appliance does notcool at allThe appliance is noisyPossible causeThermostatic control is set too low.Before freezing the appliance was not pre-cooledsufficiently.Large-sized food was put in.Too many foods to be frozen were put in.Warm foods were put in.Door is not shut properly.The thermostatic control is set too high.Plug is not connected to the mains socket properly.There is no voltage in the mains socket.Thermostatic control is in ÑSTOPî position.The appliance is not supported properly.SolutionSet higher position.Pre-cool the appliance for enough time.Cut up food.Put fewer foods to be cooled.Put foods max. at room temperature.Check if the door is shut.Set lower position.Check if the connection is proper.Check if there is voltage.Check setting of thermostatic control.Check if the appliance stands stable.Inasmuch as the advice does not lead to result, call the nearest brand-mark service.GBAll manuals and user guides at all-guides.com