AUTOMATIC GATE OPENER • Installation Manual22Push-to-Open InstallationCAUTION! Ensure the gate does not open into publicareas and does not interfere with traffic or cause traffichazards.In a push-to-open installation, the gate opener (actua-tor) is installed while the gate is in the closed positionand the gate opens out from the property.NOTE: The optional push-to-open bracket is longerthan the pivot bracket included with this kit, and isrequired for this installation (part #GAB1). You willneed two push-to-open brackets for a dual gateinstallation.Step 1 (fig. 32)Assemble the post mount bracket assembly by placingthe push-to-open bracket in between the two postmount brackets. Insert the 3/8” x 2” hex bolt throughthe center hole of the two post mount brackets and thepush-to-open bracket. Place a 3/8” washer, a 3/8” lockwasher, and a 3/8” hex nut on the bottom of the 3/8” x2” hex bolt and hand tighten.Step 2 (fig. 33a and 33b)NOTE: Gate opener (actuator) should be in the retractedor closed position before attaching the gate bracket andthe post mount bracket assembly.Attach the gate bracket and the post mount bracketassembly to the gate opener (actuator) by inserting aclevis pin through the holes in the gate bracket and thepost push-to-open bracket. Secure the clevis pins usingthe clevis pin clips.Clevis pin clipPost bracketassembly3/8” x 1 1/4”clevis pinGate opener (actuator)Clevis pin clipPost bracketassembly3/8” x 1 1/4”clevis pinGate opener (actuator)Figure 33aFigure 33bFigure 323/8” lock washerPost brackets3/8” x 2” bolt3/8” nut3/8” washerPush-To-Open Bracket