Zaxcom ZMT3 User Manual

Also see for ZMT3: User manual

Zaxcom ZMT3 User Manual Manual pdf 14 page image

Zaxcom ZMT3 Record Menu14Time Left on CardThis menu will only appear if a card was inserted prior to booting upThis page displays the remaining record time left on the card as well as the time already recorded on the card.Automatic Record after Boot upRecord on boot up allows the onboard recorder to automatically start recording after the ZMT3 boots up. ON - The onboard recorder will automatically start to record after the ZMT3 boots up. OFF - The onboard recorder will wait for a ZaxNet command or a manual record trigger to start recording.Recording Mode SetRecord mode sets what the recorder will do after the card is full. Regardless of this setting the card can onlyrecord 500 files. NON-LOOP RECORD - Once the card is full the recording will stop and FULL will be displayed. This settingprevents over-writing any portion of the audio. LOOP RECORD - Once the card is full, the new audio will begin over-writing the oldest audio on the card.Low Battery Stop SetLow battery stop will set the amount of time, after a low battery warning occurs, the on-board recorder willclose the current file and stop recording.This is to prevent possible file corruption if the unit constantly powers off and on due to a dead battery. NEVER STOP - The onboard recorder will not stop recording unless it is manually stopped by a key press, orwhen it receives a stop command via ZaxNet or if the battery dies. Any interval from 1 to 99 minutes - Once the battery indicator starts blink a low battery warning theonboard recorder will continue to record for the time set here - then it will close the file and stoprecording.TIME LEFT 20 HTIME USED 4 H____RECORD ON BOOTUPOFFRECORD MODE:LOOP RECORDLOW BATT STOP:NEVER STOP