R E M OT E P R O G R A M M I N G R E M OT E P A G E 3 53374-OProgramming the Remote Program yourremote towork with avast range ofbrand namedevices.Programming your Zenith remotewill allow you to use one remoteto work up to 7 different things.Not all devices will work with yourZenith remote control.1234567PRGCABLE VCR AUX TVENTERFLASHBKCHANNELCHANNEL1 2 34 5 6708 9MENUREWINDRECORDPIPSWAPFREEZPAUSE TIMERPLAYSTOPSURF MUTEPOWERVOLUME VOLUMEQUITCCFFWDTV/VCRSOURCE67354The device you want to program shouldbe on.On the chart on page 39/40, findthe type of device you’reprogramming, and then find the brandname. Make a note of the three-digitcode, you’ll need it soon.Press and hold the PRG key. It’s recessedso it doesn’t get pushed accidentally.Use a small object. When the indicatorlight turns on, you can release the key.Push the key name with the type ofdevice you’re programming (VCR, CABLE,AUX, TV).Using the number pad, enter the threedigit code you found on page 39/40.Press ENTER to save the code. (The indi-cator light will flash 3 times, then turnoff to indicate the code is valid.)Aim the remote at the device and pushthe POWER key. It should turn off. Ifnot, try the other codes listed and con-tinue from step three.Note: To reset remote to factory set-tings, enter 9-1-1, in step 5.Mini glossaryPROGRAMMING Procedure to set up remote to operate other equipment.PRG Programming key.DEVICE Infra-red remote controllable electronic accessory.