Zenith A27B43 Operating Manual

Also see for A27B43: Operating guide & warranty

Contents

Zenith A27B43 Operating Manual Manual pdf 6 page image

See diagrams at right to hook upyour Entertainment Machine.Remove the back of the remoteand put in three AAA batteries.Plug in your TV. Do not plug itinto a switched outlet.Go to page 13 to Auto Programyour Entertainment Machine.3376-OI N S TA L L AT I O N S TA N DA R DP A G E 6Connect anantennato yourEntertainmentMachine.Hook Up Your Antenna to the TVMini glossary75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wiresticking through the middle, and it screws onto the threaded Antenna/Cable jack on the back of your TV.300 TO 75 OHM ADAPTER A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about aninch long with two screws on one end and a round opening with a wire sticking out on the other end.RF coaxial wire(75ohm)Antenna TV backTV back panel(expanded view)Antenna/ CableTV backFlat wire(300 ohm)Antenna300/75 ohmAdapterTV back panel(expanded view)Antenna/ CableIf you have a 75 ohm RF cable,then you don’t need any adapters!Remember, when screwing RFcables onto jacks, clockwise tight-ens, and counterclockwise loosens.A 300 to 75 ohm adapter is notincluded with your ZenithEntertainment Machine.120V60Hz1234back of remoteFlat-Wire Antenna to AdapterRound Antenna Wire