Zenith B50M88W Operating Manual & Warranty

Zenith B50M88W Operating Manual & Warranty Manual pdf 47 page image

P A G E 4 7206-3486-OTroubleshooting, cont’dNot able to add a 3 digitchannel number.Not able to lock video lockfeature in parental control.Remote control doesn’t work.Menu options can’t bechanged or selected.No picture or soundwhen any non-cable sourceis selected.Weak or no Stereo Soundwhen using a stereo VCR.The PIP inset is black orlacks contrast.The PIP inset is “snow” whenthe source is Ant/Cable 1.Time is incorrect.• Press the 1st digit of your channel number, wait until 2 dashes appear to theright of your number than add the other two digits.• Exit out of Parental Control menu. Press the source button on your remote andchange the source to Video 1. Then you can reenter the parental control menuand lock the video lock. You must do this same process to unlock the videolock.• Make sure the batteries are fresh and installed properly.• Try unplugging your Entertainment Machine for a few minutes,then plug it back in.• Check to see if the source equipment has been turned on.• Make sure that the connections are secure on the back of your EntertainmentMachine and on the source equipment.• Check to see if all the connections are secure.• Look in the Audio mode menu to see if all the settings are correct.• You are using channel 3 or 4 to view your VCR. No stereo sound is presentunder that decision.• You might want to adjust the PIP picture settings under the PIP menu.• Check that all the wires are connected properly.• Check to see if your input source for PIP is set correctly.• Look to see if the TV/VCR button on your VCR has the TV selected.• Make sure the time was set initially. Probably power was lost.