Zenith H2546DT Installation And Operating Manual, Warranty

P A G E 3 1206-3492-AAccessing the Installer MenuThe Installer menus are accessed by using the remote control. Just pressand hold MENU (about 8 seconds) until the display changes, then press 9,8, 7, 6, then ENTER. To exit the Installer Menu, press ENTER again. Anychanges you make will be stored in nonvolatile memory.The Installer Menu opens with item 03 VERT POS. Press the Up/Down arrowkeys to sequence through the various items. Or, access an item directly byentering the line number, then pressing MENU. For example, to access theStart channel/volume feature which is on line 10, press 10, then MENU. Tochange a current setting use the Left/Right ADJ keys.Using the Installer MenuItems 00-27 are immediately accessible only upon entering the InstallerMenu. Their numbers, descriptions, ranges, factory default settings, and aplace for listing any changes made on-site are given below. A second sec-tion of the Installer Menu that is intended for qualified service techniciansonly is not shown (items 28-201). Normally these items do not requireadjustment.Options in the Installer Menu:Installer Menus1391-00 01.19 V 0103 VERT POS 15XX/XX/9X TE11111111Use the Installer Menus to make adjustments to operational settingsInstaller should leave item 00 FACT MODEset to 0 (default). Items 28-201 are ser-vice-type adjustments and only qualifiedtechnicians having specialized test equip-ment should access them.Item Description Range Fact. Set Recommend. Setting00 FACT MENU 0 - 1 0 Leave default set 001 PRESET PX* See note page 32 0 - 1 102 POWER MANAGE 0 - 7 003 VERT POS* See note page 32 0 - 30 1504 HORZ POS* See note page 32 0 - 45 3405 BAND/AFC 0 - 7 006 MIN VOLUME 0 - 63 007 MAX VOLUME 0 - 63 6308 AC ON 0 - 1 09 KEY DEFEAT 0 - 1 010 STRT CH/VOL 0 - 255 25511 HOSPITAL MODE 0 - 2 0 Leave default set 012 CHAN LOCK 0 - 1 013 GHOST CH. 0 - 1 014 SCAN MODE 0 - 3 0 Leave default set 015 TEXT MODE 0 - 1 116 SLEEP TIMER 0 - 1 017 ALARM 0 - 1 018 CH. OVER RIDE 0 - 1 119 OLD OCV 0 - 1 0 Set to 1 for Spectramate Systems20 CAPTION LOCK 0 - 1 021 FUNCTION PRE 0 - 1 022 FEATURE LEVEL 0 - 1 1 Leave default set 123 NTSC SCANCARD 0 - 1 124 STRT CH IN SM 0 - 1 025 V-CHIP 1 0 - 1 126 MAX BLOCK HRS 0 - 99 1227 STRT AUX SRCE 0 - 6 4