Zenith Hydro Tap Installation and Operating Instructions - 81467 - February 2005 Page 11 of 20Setting the Energy Saver Timer (products with this feature only)Normal Operation (not available on HT boiling only series)Set TimeTo change time, press either Mode ∧ or Mode ∨ button until Set Time is onthe display screen. Press ∧ Adjust button to increase time or ∨ Adjust buttonto decrease time. Time increases or decreases in increments of one minute.Hold the Adjust buttons down for rapid increases or decreases.Set DayPress either Mode ∧ or Mode ∨ button until Set Day is displayed.Press ∧ Adjust or ∨ Adjust to select day.Filter Life ( factory set at 6000 litres )Press either Mode ∧ or Mode ∨ button until Filter Life is displayed.Press ∧ Adjust button to increase Filter Life or ∨ Adjust button to decreaseFilter Life.Filter Life increases in 1000 Ltr increments to a maximum of 10000 Ltrs.Reset Litres FilteredThis function is to reset the Filter Change display after a filter has reached theend of its life (refer to “Replace Filter Instructions” section of this document).Press either Mode ∧ or Mode ∨ button until Litres Filtered is displayed. Press∧ Adjust once and “Reset Counter” will be displayed, press ∧ Adjust buttononce and “Are You Sure” will be displayed.Press ∧ Adjust once and Litres Filtered will be reset to 0.Activating Sleep ModeThis mode allows the HydroTap to go into Energy Saving mode. In this modethe unit will go to “sleep” after a pre-determined period of inactivity. Press eitherMode ∧ or Mode ∨ button until Sleep Mode is displayed. Press ∧ Adjust onceto select 2 Hours or twice to select 4 Hours. When the period of inactivitypasses, the display will show “Sleep Mode”. During sleep mode the Red LED ontop of the tap lever will flash slowly.Activating On / Off ModePress either Mode ∧ or Mode ∨ button until "Monday On" is displayed. To set thetime for the unit to turn on press ∧ Adjust button until required time is reached.To set the time for the unit to turn Off press Mode ∧ button once and Monday Offwill be displayed. Now press ∧ Adjust until required time is reached.If each individual day is to have an “On / Off” time, these steps need to berepeated for each day and for each "On / Off" time.Mode Plus ButtonMode Minus ButtonPlus Adjust ButtonMinus Adjust Button