Zenith P50W38 Service Manual

Also see for P50W38: Installation and operating guide Installation and operating guide Installation and operating guide

Contents

- 4 -ControlsControlsConnection OptionsConnection OptionsR ( )( )( )( ) LRS-232C INPUT(CONTROL/SERVICE)EXTERNAL SPEAKERY P B P R (MONO)R AUDIO LR AUDIO LS-VIDEO AC INPUTAUDIO INPUTVIDEO INPUTAUDIO INPUTAUDIO INPUT REMOTECONTROL COMPONENT INPUTDVI INPUT RGB INPUT RGB OUTPUT11. EXTERNAL SPEAKER (8 ohm output)Connect to optional external speaker(s).* For further information, refer to ‘Speaker & SpeakerStand’ manual.2. RS-232C INPUT (CONTROL/SERVICE) PORTConnect to the RS-232C port on a PC.3. DVI (Digital Visual Interface) INPUT/RGB INPUT/AUDIO INPUT JACKSConnect the monitor output connector from a PC to theappropriate input port.4. RGB OUTPUT PORTYou can watch the RGB signal on another monitor, connectRGB OUTPUT to another monitor’s PC input port.5. REMOTE CONTROLConnect your wired remote control to the remote controlport on the Monitor.6. COMPONENT INPUT/AUDIO INPUT JACKSConnect a component video/audio device to these jacks.7. S-VIDEO INPUTSConnect S-Video out from an S-VIDEO port on a VCR to the S-VIDEOinput.AUDIO/VIDEO INPUT JACKSConnect audio/video out from external equipment to thesejacks.8. POWER CORD SOCKETThis Monitor operates on an AC power. The voltage is indi-cated on the Specifications page. Never attempt to operatethe Monitor on DC power.Back Connection PanelBack Connection PanelVOL.MENUINPUT SELECTON/OFFMain Power Button INPUT SELECT Button VOLUME (FF,GG) ButtonsPower Standby IndicatorIlluminates red in standby mode,Illuminates green when theMonitor is turned on.Remote Control Sensor MENU ButtonEE, DD ButtonsFront Panel ControlsFront Panel Controls2 4 53 7 86- This is a simplified representation of front panel.Here shown may be somewhat different from your monitor.DESCRIPTION OF CONTROLS