Zenith P60W38 Installation And Operating Manual

Also see for P60W38 Series: Installation & operation guide Service manual Service manual

Zenith P60W38 Installation And Operating Manual Manual pdf 11 page image

Owner’s Manual 11InstallationExternal Equipment ConnectionsExternal Equipment ConnectionsNOTE: Not all cables shown are included with the plasma display.- To avoid picture noise (interference), leave an adequate distance between the VCR and Monitor.- Use the ISM Method feature to avoid having a fixed image remain on the screen for a long period of time. Typically a frozen stillpicture from a VCR. If the 4:3 picture format is used; the fixed image, shown at the sides of the screen, may remain visible onthe screen.How to connect1. Connect the provided BNC-RCA adapter to the monitor’s VIDEOINPUT.2. Connect the audio and video cables from the VCR's output jacks tothe monitor input jacks, as shown in the figure.When connecting the monitor to VCR, match the jack colors (Video= yellow, Audio Left = white, and Audio Right = red).Mono VCR: Connect the video output cable from the VCR to theVIDEO input on the monitor.S-VIDEO VCR: Connect the S-Video output cable from the VCR tothe S-VIDEO input on the monitor. (Note that S-Video offers higherquality).How to use1. Insert a video tape into the VCR and press PLAY on the VCR.(Refer to the VCR owner’s manual.)2. Use the INPUT SELECT button on the remote control to selectVideo.(If connected to S-VIDEO, select the S-Video input source.)VCR SetupVCR SetupS-VIDEO OUTIN(R) AUDIO (L) VIDEOY PB PR (MONO)R AUDIO LR AUDIO LS-VIDEO AUDIO INPUTAUDIO INPUT COMPONENT INPUT VIDEOINPUT- After subscribing to a cable TV service from a local provider and installing a converter, you can watch cable TV programming.The monitor cannot display TV programming unless a TV tuner device or cable TV converter box is connected to the Monitor.- For further information regarding cable TV service, contact your local cable TV service provider(s).How to connect1. Connect the provided BNC-RCA adapter to the monitor’s VIDEOINPUT.2. Connect the audio and video cables from the Cable Box's outputjacks to the monitor input jacks, as shown in the figure.When connecting the monitor to a Cable Box, match the jack colors(Video = yellow, Audio Left = white, and Audio Right = red).How to use1. Use the INPUT SELECT button on the remote control to selectVideo.2. Select your desired channel with the remote control for cable box.CableCable TV SetupTV SetupTVVCR RF Cable(R) AUDIO (L) VIDEOY P B P R (MONO)R AUDIO LR AUDIO LS-VIDEO AUDIO INPUTAUDIO INPUT COMPONENT INPUT VIDEOINPUTVCRCable Box