Zenith Presentation H27E44DT Installation & Operating Manual

Also see for Presentation H27E44DT: Installation / operating guide | warranty

P A G E 4 3206-3753Continued from previous page.11 STRT CHANNEL (Start Channel)When active, this function allows you to determine the initialchannel number when the TV is turned ON. This feature is usefulfor an in-house information channel, since the TV would alwaysselect that channel when it is turned on. Setting this to 255 caus-es the last channel viewed when TV was turned off to be the tunedto channel when the TV is turned on again.The range of values is 0 - 255. Use (adjust) keys to choose num-bers that determine the start channel.12 STRT VOLUME (Start Volume)When active, this function allows you to determine the initial vol-ume level setting when the TV is turned ON. This feature is usefulfor an in-house information channel, since the TV would alwaysselect that channel when it is turned on. When inactive, the vol-ume level and channel retain the settings when the set was lastused.The range of values is 0 - 63, 255. Use (adjust) keys to choose:(1) With number 255, the feature is inactive. (2) Set the volumelevel as desired before exiting the installer menu.13 HOSPITAL MODE (Leave set to 0)14 CHAN LOCK (Channel Lock)When set to 1 the CHAN LOCK is on. CHAN LOCK is ideal if a cablebox (or similar) is the sole source for programming—and the TVmust always be on the same channel. Changing channels withChannel Up/Down or keypad numbers is impossible. Channel Lockis inactive when set to 0 (default).Generally, this feature is used in connection with START CHANNEL(line 11) where the start channel may, for example, be set to 3 or4. If the start channel is 3 then the TV will remain on channel 3.NOTE: When channel lock is active AUTO PROGRAM and CH.ADD/DEL in the SETUP MENU are not active.15 GHOST CH. (Ghost Channel)When set to 1, the current channel number is displayed in theupper right corner of the CRT. The number moves slightly to pre-vent damage to the screen. The default is “0” or OFF.NOTE: When captions are on, the “ghost channel” is not displayed.16 SCAN MODE (Leave set to 0)17 TEXT MODEDetermines whether TEXT 1, TEXT 2, TEXT 3, or TEXT 4 decoding isenabled when TEXT is turned on (either from the Setup Menu ordirectly with CC on the remote).TIP: Set Text Mode to 1 only if text is offered in your video sys-tem.18 SLEEP TIMERWhen set to 1, the SLEEP TIMER feature may be used (but no mes-sage is displayed prior to turn-off). When set to 0, the sleep timeris not available.19 CH. OVERRIDE (Channel Override)When set to 1, the user is allowed to select channels with eitherChannel Up/Down or by direct number keypad entry. When set to0, only those channels that are entered for scanning may beselected.20. OLD OCV (On Command VideoTM)Set to 1 for operation with systems from On Command Corporation.21. CAPTION LOCKSet to 1 to restore previous caption On/Off state after TV turns offwhen set to 0, captions are always off when TV is initially turnedon.22. FUNCTION PRESet to 0 to suppress CHANNEL PREVIEW FUNCTION with some payper view systems.23. FEATURE LEVELDefault set to ZEN 1 for Zenith IR remote control operation. SetO, P LBL for Zenith Private Label IR remote control operation.Installer MenusNote: Installer should leave item 23 FEATURELEVEL set to 1 (default).Items 24-93 are service-type adjustments andonly qualified technicians having specializedtest equipment should access them.