Zenith R40W46 Installation And Operating Manual

Also see for R50W46: Specification sheet Installation and operating guide Service manual Service manual

Zenith R40W46 Installation And Operating Manual Manual pdf 13 page image

Off Timer/On Timer SetupOff Timer automatically switches the TV to standby mode at the presettime.On Timer automatically turns the TV on at the preset time and tunes tothe specified channel.1. Press the menu button and then use D / E button to select theTimer menu.2. Press the G and then use D / E button to select Off timer or Ontimer.3. Press the G and then use D / E button to set the hour.4. Press the G and then use D / E button to set the minute.5. For only On timer function: Press the G and then use D / Ebutton to set the desired channel.Press the G and then use D / E button to set the volume level atturn on.6. Run/Hold is used to activate or deactivate preset on/off timers.Press the G and then use D / E button to select Hold or Run.7. Press the exit button to return to TV viewing.Notes• Two hours after the set is turned on by the on timer function, it willautomatically revert back to standby mode unless a button has beenpressed.• This function works only in standby mode.• If the same time is set for the on time and off time, only the off timeoperates.Auto Off SetupIf an input signal is not present, the TV is automatically switched tostandby mode after 10 minutes.1. Press the menu button and then use D / E button to select theTimer menu.2. Press the G and then use D / E button to select Auto off.3. Press the G and then use D / E button to select On or Off.4. Press the exit button to return to TV viewing.13CH.}}{+ Move+++ Adjust ++Å + BackClock {{Off timer {{On timer {{Auto off {{Timer- - : - - AMTV 2Vol 30Hold- - AMCH.+ Move++Å }}BackClock {{Off timer {{On timer {{Auto off {{TimerOnOffOff