Zenith SM3583BT Operating Manual & Warranty

Zenith SM3583BT Operating Manual & Warranty Manual pdf 10 page image

THE FIRST TIME YOU OPERATE YOUR TVSTEP 1. CONNECT THE POWERA. Plug your TV into an unswitched AC power source.B. Turn the TV ON by pressing OFF-ON.Do not plug 'I?V into switched outleton cable-_2V decoder or VCRSTEP 2. SELECT YOUR VIEWING SOURCEA TV source refers to the equipment connected to the TV thatsupplies the picture and sound to your TV. You select theviewing source by using the SOURCE MENU.To Access SOURCE MENU1. Press SOURCE on the remote control to view theSOURCE MENU.2. Press SOURCE repeatedly until the desired source ishighlighted.3. Press ENTER to return to normal viewing.50UREEIANT/CABLE- 1ANT/CABLE- 2VIDEO 1VIDEO 2S-VIDEO 1VIDEO 3S-VIDEO 2NOTE: The antenna or cable must be connected to the "IVbefore using AUTO PROGRAM to find available channelsSTEP 3. USE AUTO PROGRAMAUTO PROGRAM finds all available channels and storesthem in the memory of the TV for use by CHANNEL (CH)Up/Down. Use AUTO PROGRAM only when you firstinstall your TV, or when you permanently change theconnections to the TV. For example, when you replace theantenna with a cable-TV system.NOTE: AUTO PROGRAM can only be used with ANT/CABLE 1 or 2 Source selection.To Use AUTO PROGRAM1. Press MENU on your remote control repeatedly untilthe SETUP MENU appears.2. Press SELECT (SEL) UP/DOWN to highlight AutoAUTO PROGRAM iCH. ADD/DEI_CH. LABELSTUNING BANDAUTO TUNINGSOURCE IDCLOCK SETCAPTIONSSetup Menu with Auto Program Highlighted.4.Program.Press ADJUST (ADJ) Left/Right to start Auto Program.Use AUTO PROGRAM independently for each AN-TENNA or CABLE signal source connected to yourTV. Select one source by using the SOURCE MENU(ANT/CABLE 1 or 2) and use AUTO PROGRAM.When" completed, select the other source and useAUTO PROGRAM again.STEP 4. TIME FUNCTIONSSet Clock In TV1. Press Menu until the SETUP MENU is selected.2. Press SELECT (SEL) to highlight CLOCK SET thenuse the number buttons on the remote to enter thecorrect time.3. Select AM or PM using the TIMER key on the remote.4. Press ENTER (ENT) to start the clock.When Some Channels Are Not FoundAUTO PROGRAM finds ,3ni!yactive channels and storesthem in the favorite channel memory. You can add channels tothose stored in memory by u_;ing CH. ADD/DEL.] [ 10:00AMAUTOPROGRAMCH.ADD/DELCH.LABELSTUNING BANDAUTOTUNINGSOURCE[DCLOCK SETCAPTIONS_m__ JSelecting Clock Set(continued on next page)2735-B 2-- 1