Zenith TRK4000 User Manual

Contents

remote programming

Zenith TRK4000 User Manual Manual pdf 3 page image

ZENITH REMOTE MANUAL 3 TRACKBALL REMOTESPROGRAMMING INSTRUCTIONSIf you’re using Zenith products, the remote is alreadyprogrammed for most common codes: TV = 101, VCR =201, CABLE = 353, and AUX = 401. For other brands, orif your remote fails to control your Zenith products, you’llhave to program the remote. Make sure the batteries areinstalled and follow these steps for each product:1. Make sure the equipment is turned on.2. Point the MBR Trakball remote at the device you’reprogramming, press MUTE and FLSHBK at the sametime. Hold until one of the mode indicator LEDslights.3. Use the MODE Right/Left button to select the appro-priate mode for equipment.4. With the Number Keypad, enter the three digit codeand press ENTER. If the code is accepted, the modeindicator Led will blink three times, If it is notaccepted, the Led will not blink.NOTE: The TV and VCR modes will only accept codes forthose types of products. The AUX 1, AUX 2, andCable modes will accept codes for any kind of product.5. Push the POWER button to turn off the equipment. Ifnothing happens, repeat the process from step 1,and try the next code number.NOTE: To quit programming before you enter a code, justpress the QUIT button on remote.AUTO FINDIf none of the codes in the code table operate yourequipment, use Auto Find to search for the proper code.1. Turn on the device you want to operate.2. Press and hold MUTE and FLSHBK until the indicatorlight turns on.3. Press MODE Left/Right until the indicator light isunderneath the device needed to be programmed.4. With the NUMBER keypad, enter the code “0-0-0”,then press the ENTER key right away.5. Aim remote at the correct device and push the POWERbutton. Allow a second to pass, then push the Powerbutton again. Repeat until the device turns off. Ifthe indicator light does not turn off while you pushthe Power key, all the codes have been tried and yourdevice can’t be programmed.6. Push ENTER to save the code. The indicator light onthe remote will blink three times and then turn off.7. Press POWER to turn the device back on.NOTE: You can get out of Auto Find by pressing the Quitbutton.CABLE BOX VOLUMEThis remote can control the cable/converter box volumeand muting (instead of the TV’s) if available on yourequipment.1. Program the cable/converter box normally.2. Press MUTE and FLSHBK at the same time. Hold untilthe mode indicator LED lights.3. Use MODE to position the indicator light under Cable.4. This time, enter the special code 3-9-9 instead ofthe product code.5. Press and release ENTER to save. The indicator lightshould blink and then turn off.VOLUME OVERRIDEThese remotes can override TV, VCR, or Video Disk Playervolume functions with an amplifier’s volume and muting.1. Program the amplifier normally.2. Press MUTE and FLSHBK at the same time. Hold untilthe mode indicator LED lights.3. Use MODE to position the indicator light under thedevice name used for the amplifier.4. This time, enter the special code 4-9-9 instead ofthe product code.5. Press and release ENTER to save. The indicator lightshould blink and then turn off.REMOTE PROGRAMMING