Zenith Z52DC2D Installation And Operating Manual

Also see for Z62DC1D: Installation and operating guide, warranty Specifications

14 DLP Projection TVNote: The TV will let you know when the TV(analog antenna), DTV(digital antenna), CATV(analog cable) and CADTV(digitalcable) channel scans are complete.• To improve the picture quality in a poor signal area,please purchase a signal amplifier and install properly.• If the antenna needs to be split for two TV’s, install a “2-Way Signal Splitter” in the connections.• If the antenna is not installed properly, contact your deal-er for assistance.ANTENNAINSignalAmplifier3. Analog and Digital TV signals provided on cable and antennaAntennaRF Coaxial Wire (75 ohm)Bronze WireTurn clockwise to tighten.Cable TV WallJack RF Coaxial Wire (75 ohm)CABLEINANTENNAINConnection Option 1Set VCR output switch to channel 3 or 4 and then tune theTV to the same channel number.Connection Option 21. Connect the audio and video cables from the VCR's outputjacks to the TV input jacks, as shown in the figure.When connecting the TV to VCR, match the jack colors(Video = yellow, Audio Left = white, and Audio Right = red).If you connect an S-VIDEO output from VCR to the S-VIDEOinput, the picture quality is improved; compared to connectingonly the Video input.2. Insert a video tape into the VCR and press PLAY on theVCR. (Refer to the VCR owner’s manual.)3. Select the input source with using the INPUT button on theremote control. Note that this TV finds the connected inputsources automatically for AV 1-2 and Component 1-2.Do not connect to both AV1-2 and S-Video at thesame time. In the event that you connect both AV andthe S-Video cables, only the S-Video will work.VCR SetupVCR SetupS-VIDEO(R) AUDIO (L)OUTINVIDEO3 4OUTPUTSWITCHANT OUTANT INRGB(PC/DTV)S-VIDEOPRPBYMONORGB INCOMPONENT IN21(L)(R)AUDIORGB/DVI(L)(R)AUDIOVIDEO(L)(R)AV IN 1 AV OUTDIGITAL AUDIOOPTICAL OUTSERVICE ONLYVIDEOAUDIOHDMI/DVI INCABLEINAC INANTENNAINVCR Rear1 2Bronze Wire