206-3652Connecting antenna14* To get better picture quality, adjust the direction of antenna.l In case of wall antenna socket in apartment houses, connect the antenna cable as shown below.(Use the correct type of antenna cable to the type of wall antenna socket.)DC 12VANT IN+75 ΩCOMPONENT INPUT(4BP Pwall connecting portApartments antenna input portbronze wireTurn clock arise totighten.antennaconverter300Ω flat cable75Ω round cablel This type of antenna is usually used at common private houses.DC 12VANT IN+75 ΩCOMPONENT INPUT(48BP PDC 12VANT IN+75 ΩCOMPONENT INPUT(48BP PUHFantennaVHF antennaantenna input portbronze wireTurn clock arise totighten.antennaconverter300Ω flat cable75Ω round cable* In case of 75Ω round cable, insert the bronze wire and then tighten the connecting nut.And in case of 300Ω flat cable, connect the twisted wire to the antenna converter andthen connect the converter to the antenna input port.* When using 75Ω round cable, do not bend bronze. It may cause poor picture quality.* In poor signal area, you can get betterpicture quality if you install the anten-na like the figure as shown right.* If an antenna is divided to two TVsets, use “signal divider” for connect-ing.signalamplifierUHFVHFPrivate houseConnecting to wall antenna socketConnecting to wall antenna socketConnecting to outdoor antennaConnecting to outdoor antenna