Zenoah HB2311EZ Workshop Manual

Also see for EB7000: Owner's manual User manual

Contents

Zenoah HB2311EZ Workshop Manual Manual pdf 29 page image

214. Service Guide4-7 Crankcase AssemblingBearings, snap ring, oil seal configuration and installation position differ depending on type.Properly install each part and reassemble the crankcase referring to the corresponding type’s drawing.For bearing and oil seal installation, refer to the explanation on page 23.HB23 Series, HBZ26 SeriesEBZ30 SeriesEB4300【【【【Fan Side】】】】Push the oil seal within 0 to0.5 mm (0.02 in.) from thecrankcase surface.Oil Seal【【【【Starter Side】】】】Oil SealAlign the oil seal surface withthe crankcase surface.BearingPush the bearings until theycontact the snap ring.BearingPush the bearings until theycontact the crankcase.Snap RingCrank CaseConstructionPush the oil seal within 0 to0.5 mm (0.02 in.) from thecrankcase surface.Oil Seal【【【【Fan Side】】】】【【【【Starter Side】】】】BearingPush the bearings until theycontact the crankcase.Snap RingDo not cover the lubricationhole with the snap ring.Lubrication HoleSnap RingPush the oil seal within 3.3to 3.8 mm (0.13 to 0.15 in.)from the crankcase surface.Oil SealBearingPush the bearings until theycontact the snap ring.Lubrication HoleCrank CaseConstruction【【【【Fan Side】】】】Push the oil sealuntil its surfacecomes trim withthe crankcaseedge surface.Oil Seal【【【【Starter Side】】】】Push the oil seal untilits surface comes trimwith the crankcaseedge surface.BearingPush the bearings until theycontact the snap ring.BearingPush the bearings until theycontact the crankcase.Snap RingOil SealCrank CaseConstruction