Zephyr Edge Wall AED - M90ASX Installation Instructions Manual

Also see for Edge Wall AED - M90ASX: Specification sheet

Contents

Zephyr Edge Wall AED - M90ASX Installation Instructions Manual Manual pdf 22 page image

www.zephyronline.comGENERAL• Carefully read the following important information regarding installationsafety and maintenance. Keep this information booklet accessible for furtherconsultations.POWER SUPPLY CONNECTIONFor connection to the power supply refer tothe following:1. Lift the bottom part of the duct cover andsecure it carefully using adhesive tape.2. Remove the power supply cover by un-doing the (2) screws Fig. 11.3. Break through the hole on the box co-ver.4. Secure the power supply conduit to thecover.5. Connect the wires of the hood to those ofthe power supply as described. Fig.11:BLACK = L lineWHITE = N neutralGREEN / YELLOW = G ground- A double-pole switch properly rated mustbe installed to provide the range hoodpower supply disconnection.- Connect the electrical conduit to the FieldWiring Compartment using listed onduitfi ttings.- Carry out the power supplly connection inaccordance with the national electric code,ANSI/NFPA 70-1999.6. Insert the wires into the box, then close the box cover, securing it using thescrews that were previously removed.7. Remove the adhesive tape from the chimney and place the lower part of thechimney on the hood.Installation - Power Supply Connection- 22 -