Zephyr Essentials ZAN-E30CS Use, Care And Installation Manual

Also see for Essentials ZAN-E30CBS: Use, care and installation guide

Contents

Zephyr Essentials ZAN-E30CS Use, Care And Installation Manual Manual pdf 23 page image

21TROUBLESHOOTING PROCEDURESIssue Cause What to doAfter installation,the unit doesn’twork.1. The power source is not turned ON. 1. Make sure the circuit breaker and the unit’spower is ON.2. The power line and the cable locking connectoris not connecting properly.2. Check the power connection with the unit isconnected properly.3. The switch board or control board wirings aredisconnected.3. Make sure the wirings at the switch board andcontrol board are connected properly.4. The switch board or control board is defective. 4. Change the switch board or control board.Light works, butblower is notturning.1. The blower cable is disconnected. 1. Connect the blower cable.2. Debris or obstruction in motor. 2. Remove the debris or obstrunction.3. Motor defective or possibly seized. 3. Change the blower.4. Damaged capacitor. 4. Change the capacitor.5. The switch board or control board is defective. 5. Change defective part.The unit isvibrating.1. The blower is not secured in place. 1. Tighten the blower in place.2. Damaged blower wheel. 2. Replace the blower.3. The hood is not secured in place. 3. Check the installation of the hood.The blower isworking, but thelights are not.1. The LED light strip connector is disconnected. 1. Connect the LED light strip connector.2. Defective LED light strip. 2. Change the LED light strip.3. The switch board or control board is defective. 3. Change the switch board or control board.The unit turns onby itself.1. A spot light or kitchen lamp is shining directlyonto the switch controls.1. The switch controls are light sensative. Adirect light source onto the switch controlsmay disrupt switch functions.The hood isnot venting outproperly.1. Using the wrong size of ducting. 1. Change the ducting to at least 6” round orhigher.2. Using the wrong type of ducting. Flexible ductingcan reduce air flow by up to 50%.2. Change the ducting to solid rigid metalducting.3. The hood might be hanging to high from thecook top.3. Adjust the distance between the cook top andthe bottom of the hood within 26” and 34”range.4. The wind from the opened windows or openeddoors in the surrounding area are affecting theventilation of the hood.4. Close all the windows and doors to eliminatethe outside wind flow.5. Blockage in the duct opening or ductwork. 5. Remove all the blocking from the duct work orduct opening.Troubleshooting

/ 26

Related manuals for Zephyr Essentials ZAN-E30CBS