Zephyr Monsoon DCBL AK9428AS Use, Care And Installation Manual

Also see for AK9440AS: Use, care and installation guide Use, care and installation guide

Contents

Zephyr Monsoon DCBL AK9428AS Use, Care And Installation Manual Manual pdf 16 page image

14www.zephyronline.com121Installation – Horizontal Ducting Preparation12. Position blower inside liner body as shown by:1) Rest the bottom horizontal ducting bracketon the two support clips located on the interiorback wall of the liner. 2) Pivot top horizontalducting bracket to meet captive nuts on interiorback wall.13. Secure blower to captive nuts on interiorback wall of liner with (8) 3/16” x 3/8” screws,(4) screws for each bracket. Seal any gapsaround the knock-out plate by using certifiedaluminum duct tape. Plug in blower molexplug.Horizontal ducting preparation is nowHorizontal ducting preparation is nowcomplete. Refer to Page 10, Step 5 tocomplete. Refer to Page 10, Step 5 tocomplete installation.complete installation.10. (Rectangular Ducting) From inside the liner,push 3-1/4” x 10” rectangular adaptor throughthe back knock-out and secure to interior backwall of liner with (8) M4 x 6mm screws.10. (Round Ducting) From inside the liner, push8” round adaptor through the back knock-outand secure to interior back wall of liner with (4)M4 x 6mm screws.11. Secure (2) horizontal ducting blower bracketsto blower as shown above by using the (4)3/16” x 3/8” screws previously removed fromPage 12, Step 6; (2) screws for each bracket.