Zephyr Roma Island ZRM-E36BS Use, Care And Installation Manual

Also see for Roma Island ZRM-E36BS: Use, care and installation guide

Contents

Zephyr Roma Island ZRM-E36BS Use, Care And Installation Manual Manual pdf 12 page image

10www.zephyronline.comInstallation – Mounting the Hood12435Top Duct CoversTop Support FrameBottom Duct CoversBottom Support FrameThin Trim PieceThick Trim Piece5. Install electrical and duct work. A cable lock, not supplied, might be required by local codes. (FIG.E)Seal duct work with aluminum duct tape.6. Power up hood, verify all functions and check for leaks around duct tape.7. Assemble Top Duct Covers (with louver holes) together over Top Support Frame using (6) M3 x 6 screws,(3) on each side of the duct cover. (FIG. D1). Larger screw hole openings should overlap the smaller holehopenings. Note: If using hood in ductless recirculating mode you must install the air diverter plate to theTop Support Frame prior to assembling the duct covers. Turn to page 11 for more details.8. Secure Top Duct Covers to Top Support Frame by using (2) 3/16 x 1/4” screws. (FIG. D2).9. Assemble Bottom Duct Covers together over top duct covers using the final (6) M3 x 6 screws, (3) screwson each side of the duct cover (FIG. D3). Bottom Duct Covers should rest on top of the Hood Body.10. Insert the (2) Thin Trim Pieces into left and right seams of Bottom Duct Covers. (1 on each side)(FIG. D4)11. Insert the (2) Thick Trim Pieces into left and right seams of Top Duct Covers. (1 on each side)Note: Because less of the Top Duct Covers may be exposed, it may be necessary to measureand cut the Thick Trim Pieces with a hack saw before installing them into the Top Duct Covers.Measure and cut carefully.FIG. DCable LockCable LockA cable locking connector (notsupplied) might be requiredby local codes. Check withlocal requirements and codes,purchase and install appropriateconnector if necessary.FIG. EWARNING: Electrical wiring must be done by a qualified person(s) inaccordance with all applicable codes and standards. This range hood must beproperly grounded. Turn off electrical power at service entrance before wiring.!