Zephyr Tornado II AK8200AS Use, Care And Installation Manual

Also see for Tornado II AK8200AS: Use, care and installation guide Use, care and installation guide

Contents

15FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate this equipment. (Example - use only shielded interfacecables when connecting to computer or peripheral device. This device complies with Part 15 of the FCC Rules. Operation issubject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must acceptany interference received, including interference that may cause undesired operation.REMOTE CONTROL MAINTENANCE:Clean the remote control using non abrasive detergentsFollow instructions below for replacing battery.Using a small flat head screwdriver, raise the cover of the battery door (A)in order to access the battery compartment.Remove the battery and replace with Type A23 12V.Negative end of battery should face the spring inside the remote.Replace battery door and recycle old battery.Blower On/Speed SelectionBy pressing , the blower is switched On. Press again to cycle through allthree blower speeds.Blowers On/Hood OffBy pressing , the blowers will power on at the last speed setting. Pressagain and the entire hood will power off, including lights.Delay OffLights On/Dim/OffSwitch lights On by pressing once, again to dim and again to switch Off.Blower On/Speed Selection 11234Blower On/Power Off25 Min Delay Off 3 Lights On/Dim/Off4By pressing , the blower and lights will enter Delay Off mode. A dot willappear in the lower right corner of the power pack display indicating thefunction is on. The blower will change to speed 1 and shut down after 5minutes.A -+REMOTE CONTROL FEATURES:The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface suchas a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.This remote control may operate in humid environments, but not when placed on a wet surface.SYNCHRONIZATION: To create a unique link between your range hood and remote control please follow the below steps:1. With range hood off, press and hold the “lights” button on the range hood until the letter “F” shows on the display screen.2. Press the “lights” button on the remote, the lights on the hood will turn on. The synchronization is complete.Features & Controls – RF Remote Control