MANUALA INSTALLING THE HEATERCarefully remove your heater from the box and check the contents.In addition to the heater you also need to have:E a manual fuel pumpE a transportation capE these directions for useKeep the box and the packaging materials (Fig. A) for storage and/ortransportation.Remove the other packaging materials:E Remove the packaging material from the grill G. Lift the grill from the slot(Fig. B) and pull it forward.E Pull both ends of the packaging to the rear and at the same time slightlydownwards (see Fig. C).E Remove the combustion chamber from the heater and remove thepackaging underneath (see Fig. D).E Put the combustion chamber back into its place. The combustion chamberis positioned correctly when it can be smoothly moved a little to the leftand to the right by its handle E (Fig. E). Close the grill: Slightly lift it toreposition it in its slot.E Open the lid of the removable tank H and remove the piece of cardboard.Fill the removable tank as indicated in Section B.Insert the batteries into their holder M at the back of the heater (Fig. F).Ensure that the positive and negative poles match the + and - marks indicatedon the battery housing.The floor should be firm and completely level. Reposition the heater, when it isnot level. Do not correct the situation by placing books or other goods under theheater.Your heater is now ready for use.B FILLING FUELDo not fill the removable tank in the living room, but in a more suitable place(there can always be some spillage). Follow the procedure below:Make sure that the heater is switched off.Open the lid H and lift the removable tank I out of the heater (Fig. G).Note: Some drops may leak from the tank. Put down the removable tank(cap pointing upwards) and screw off the fuel cap.Take the manual fuel pump and insert the smooth, most rigid tube into thejerrycan. Make sure that it is in a higher position than the removable tank(Fig. H). Insert the ribbed hose into the opening of the removable tank.321654321453E E E E E EGBEFCD