Zip HydroTap G4 Installation Instructions Manual

Also see for HydroTap G4: User guide Installation instructions Installation instructions Installation instructions User guide

Contents

Zip HydroTap G4 Installation Instructions Manual Manual pdf 18 page image

Page 18 of 20 804052 - CS Residential- Installation Instructions - Sept 2016 - v3.01OPEN PositionCLOSED PositionONOFFStop cockoperationCommissioningNOTE: For any subsequent filter changes or any operational procedures, please refer to the HydroTap userguide, located inside the filter housing access door.1. Press [Start] [Stop] buttons to start and stop the filterflush.2. Turn the flush line stop cock ON (See diagram).3. Press [Start] and allow at least 10 litres of water to flushthrough the filter.4. The product details will be displayed in the screen.5. Once the filter flush is finished, Turn the stop cock OFFthen press [Stop] to end filter flush mode.6. Press [Next] for the Boiling Calibration screen.Have a 10L bucket or similar container (not supplied) at the ready to hold a quantity of water that will beejected while the Filter Flush Mode is in operation. Open the filter access door on the front of the HydroTapand the filter cartridge will be exposed. Located to the rear RHS of the cartridge is a flush line, approx 600mmlong and the flush line stop cock. Place the valve end of the flush line into the 10L bucket or container.5.3 - Filter Flush

/ 20

Related manuals for Zip HydroTap G4