3IMPORTANT SAFETY INSTRUCTIONSThe information contained in this technical guide is intended for Zodiac trained service personnel only.Electrical installation and repairs should only be performed by a certified electrician or Zodiac trainedprofessional. and must comply with all national electric codes (NEC, Canadian, etc.). state and local law,ordinances, codes and regulations.If you have not received training, do not attempt any of the electrical repairs presented in this document.Contact Zodiac Pool Stsyems, Inc. at 1-800-822-7933 for assistance.Read and follow all instructions carefully.When servicing equipment, basic safety precautions should always be followed including those listedbelow.TO REDUCE THE RISK OF ELECTRICAL SHOCK:• Disconnect main power to pool equipment area prior to any service or repairs.• Keep all electrical equipment at least 10 feet (3m) from inside wall of pool or spa.• Connect equipment only to a receptacle (cord models) or circuit (hardwired) protected by aground fault circuit interrupter (GFCI).• Use only copper conductors and supply wires suitable for the specific device.• Replace damaged power cord(s) immediately and use only identical replacement parts.• Do not bury power cord(s). Position cord(s) to minimize abuse from lawn mowers, hedgetrimmers and other equipment.• Do not install or service equipment if precipitation is present or imminent.TO REDUCE EQUIPMENT WATER PRESSURE HAZARD:• Always turn pump off to release pressure prior to removing or installing in-line equipment.• To avoid equipment damage, do not exceed water pressure (psi) specifications forthe device.To reduce the risk of injury, do not permit children to operate, handle or play on equipment.Failure to heed the following warnings could result in propertydamage, permanent injury or death.WARNING!