CEI-100/200 ARINC Test Program Main MenuCEI-100/CEI-200/CEI-x20 User’s Manual 45Main MenuThe Main Menu appears immediately following the Welcome Screen asshown Figure 23. In addition to a menu, each screen also containsinformation and message areas that apply to the current function. In theMain Menu screen shown below, you can see that the interface is properlyinstalled because the status line summary shows one controller ready.Transmit DataReceive DataSetup InterfaceExit to DOS1 CEI-200 ARINC controller(s) readyCondor Engineering ARINC-429 Controller Rev 1.0Main MenuFigure 23. Main MenuThis menu contains three main functions: TRANSMIT DATAThis function sets up and initiates transmissions on the ARINC429 bus. It can send an ARINC message once or repetitively at aselected interval. RECEIVE DATAThis function sets up reception of data on the ARINC 429 bus.Reception of data can be selectively triggered on label, data, or acombination of the two. SETUP INTERFACEThis function sets up certain functions on the interface, includingthe ARINC transmit and receive bit rates (100Kbs or 12.5Kbs)and the parity (even or odd). You can save and restore currentprogram settings from this menu. You can select the default radixfor most input and output data as well as the self-test function. EXIT TO DOSThis function exits the program and returns to DOS. You can alsouse the Esc key.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
