Disclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right tovary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI andthe manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2022.Note: Dimensions are nominal measurements onlySPECIFICATIONSRECOMMENDED USEMATERIALTEMPERATURE RATINGSPRESSURE RATINGSSUITABLE FOR HOT WATER UNITSCOMMERCIAL PULL OUT SPRAY AT TACHMENTDomestic304 Stainless SteelMaximum continuous working temperature 75oCIf the water exceeds 75oC, an approved temper -ing valve must be fittedRecommended minimum working pressure 0.2 BarRecommended maximum working pressure 5 BarHot and cold water inlet pressure should be equalStorage tank: YesContinuous flow: YesGravity fed system: Not SuitablennnAS/NZS 3718:2005WM-022852