aci DLP Series Installation And Operation Instructions Manual

Also see for ACCESS series: Installation & operation instructions Installation instructions and owner's manual Installation & operation instructions Installation & operation instructions Installation & operation instructions

aci DLP Series Installation And Operation Instructions Manual Manual pdf 1 page image

Installation and Operation InstructionsDLP SeriesAUTOMATION COMPONENTS, INC Version : 5.02305 Pleasant View Road I0000777Middleton, Wisconsin 53562 Page 1 of 6www.workaci.com (888) 967-5224Figure 1: DLP Dimensions and HardwarePRECAUTIONS R EMOVE POWER BEFORE WIRING. N EVER CONNECT OR DISCONNECT WIRING WITH THE POWER APPLIED . D O NOT ALLOWLIVE WIRES TO TOUCH THE CIRCUIT BOARD . A N ISOLATION TRANSFORMER IS RECOMMENDED WHEN POWERING THE DEVICE WITH 24 VAC . D O NOT RUN THE WIRING IN ANY CONDUIT WITH LINE VOLTAGE . F AILURE TO WIRE DEVICES WITH THE CORRECT POLARITY WHEN USING A SHARED TRANSFORMER MAY RESULT INDAMAGE TO ANY DEVICE POWERED BY THE SHARED TRANSFORMER.MEDIAThe DLP can be used to monitor the differential pressure in any application that uses dry air or inert gas.DIN RAIL MOUNTING (Optional Accessory Ordered)Attach the DIN Rail Mounting accessory to the back of the enclosure using the two screws provided. To mount the sensor on the DINRail, place the bottom of the DIN Rail Clip into the 35mm DIN Rail and push the unit upward to engage the spring clip. Now press thetop of the unit back until it locks into place (see Figure 2).Figure 2: DIN Rail Mounting