b2audio Quattro Owner's Manual
          | |
.Feel free to visit us at: www.b2audio.com & at facebook; www.facebook.com/b2audio9The protection circuits of the amplifier prevents severe damages from faulty conditions & improper use. If the unit sensesThe protection indicatior will switch on due to short circuit connection & speaker overload, thus the amplifier will be turned off.Prior to inspecting the occurred problem, turn all levels down & all power off, then carefully check the installation forwiring mistakes, shorts or faulty ground (GND). If the amplifier shuts down due to excessive heat, the protection indicator willnot light; please allow time for the unit to be cooled off. Before removing your amplifier, refer to the list below and follow thesuggested procedures step by step. If not at ease, contact an authorized installer which can assist you.PROTECTION LED IS LIT ONCE THE AMPLIFIER IS TURNED ONFUSE BLOWINGMeasure the speaker impedance & that it is in accordance with the configuration.Check speaker shorts.Ensure airflow around the amplifier is sufficient & that the amplifier is not installed inareas of excessive vibration.AUDIO OUTPUT INSUFFICIENT - DISTORTED SOUNDEnsure that the gain settings on the amplifier is matched with the output level of the head unit.Adjust the head unit volume.Check speaker shorts.Adjust the crossover frequencies in accordance with the setup.HIGH HISS-ENGINE NOISE IN SPEAKERSMeasure the speaker impedance & that it is in accordance with the configuration.Inspect the power cable for shorts along with vehicle chassis.AMPLIFIER DOESN’T TURN ONMeasure voltage on the +12V terminal.Ensure that the remote terminal has min. 13.8V DC remote connection.Recheck the ground (GND) connection. Inspect the in-line fuses.Check the protection LED is not on.Check shorts on speaker wires.Disconnect the speaker cables and reset the amplifier. If the protection LED is still lit,then the amplifier is defective.OVERHEATINGIf no output at all, check the RCA connections & the cable itself.Ensure that all signal transferring wires (RCA, speaker cables etc) are kept seperately / away fromthe power and the ground wires.Bypass all electrical components between the Head unit and the amplifier.Connect the Head unit directly to the amplifier’s input. If the noise is eliminated, the unit bypassedis the one causing the noise.Remove the existing ground wires for all electrical components installed. Ensure that the point ofground is 100% metal which has been grinded free of rust, paint etc.Replace the ground cable from the OEM battery / alternator and ensure it is grounded accordingly.Test the battery and alternator load (can be carried out by a professional).Ensure that the vehichle’s electrical system is in a good condition, this includes distributor, alternator,spark plugs / wires, voltage regulators etc.TURN ON THUMPDisconnect the signal input to the amplifier, then turn it on and off.a) If the noise is cancelled, then connect a delay turn on module on the REM wire running fromthe source unit to the amplifier.b) Use another 12V source for REM lead to the amplifier. If the noise is cancelled, use a relayto isolate the amplifier from the turn on thump.4. Troubleshooting |
Related manuals for b2audio Quattro
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine