banks Derringer Owner's Manual
Also see for Derringer: Owner's manual
                                                | |
14 97671 v.1.1The following procedureand images are for demonstrationpurposes only. Please refer to section“1.4 Vehicle Specific Instructions”of the manual for further guidance onlocating sensor, routing and mountingDerringer application specific harness.However, installation process shouldbe similar.1. Connect the Derringer module tothe Derringer harness and mount it ina secure location with provided zip tie.See Figures 1.3-1Tip: Mount the Derringer moduleclosest to the side your vehicles’firewall wiring harness gasket islocated. This will be helpful whenconnecting the starter cable andrunning it to the OBDII connectorinside the vehicle.2. To route the Derringer startercable through the firewall wiringharness grommet, and into the drivercompartment start by feeding the6-pin end of the Derringer startercable through firewall gasket.See Figures 1.3-2 & 1.3-3. A wirecoat hanger is helpful for pulling theharness through the two sides of thefirewall wire harness grommet. Takecare not to damage the factory wireharness nor the starter cable.3. Plug the round connector end of theBanks starter cable into the Derringerand secure it by rotating the locking ringclockwise towards its locking position.See Figures 1.3-4 & 1.3-5 & 1.3-6.Figure 1.3-2Figure 1.3-5Figure 1.3-4NOTE:Figure 1.3-3Figure 1.3-1AlignmentMARKSection 1.3DERRINGER TUNER INSTALLATION"LOCK" ICONLOCKUNLOCKNEW DERRINGERCABLE ADDITIONLOCATION |
Related manuals for banks Derringer
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine