dacell DN-AM210 User Manual
              | |
12EX) 2mV/V310 KAVVout BVout : Output voltage of amplifier when the maximum output of transduceris inputtedVB : Bridge proper voltageA : Amplifier gainK : Output sensitivity of transducer (mv/V)For shunt compensation, error can be occurred by wiring, bridge resistance orproper voltage while stress analysis is being done. So shunt compensation isvery important when you set the amplifier gain. Also when you use the analoguetransducer (force, torque and pressure etc), please fully understand the size oftransducer and the form of output so that you can select correct amplifier gainaccordingly.4-11. Filter controlAs standard, ST-AM210 has 2 pole standard low-pass filter installed.Controllable switch is located on the front side of amplifier and the signal noise is10Hz, 100Hz, 1kHz, 10kHz. Wide-band can be controlled by band pass. This cut-off frequency is normally originated in 30% (-3dB) of output. For control, pleaseturn the rotary selector switch located on the front side of the amplifier.L.P.F Characteristic |
Related manuals for dacell DN-AM210
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine