®Configuring the DriveRack™ Section 3DriveRack™29the display will appear something like this:Note: Linking modules past the crossover section will be dictated by the selected crossovertype. For example, if a two-way crossover is used, you will be limited to linking theeffect modules past the crossover to highs and lows.From Configuration mode, the user has the ability to select and position the desired crossoverwithin the crossover module section. You also have the ability to change the crossover outputroute while you are selecting and moving crossovers. The procedure is as follows:• From Program mode, press and hold the PROGRAM/CONFIG button until you are inConfiguration mode. The display will appear as follows:• At this point use the Parameter 1 and 2 knobs to move to the crossover section.• Once the crossover section has been selected, use the PARAMETER 1 knob to selectthe desired crossover type.• If you wish to move a crossover type, simply rotate the PARAMETER 1 knob counterclockwise until the display appears something like this:3.7 Selecting and Moving CrossoversDriveRack™ User Manual