easyRAID Q12-U4R2 Hardware User Manual

easyRAID Q12-U4R2 Hardware User Manual Manual pdf 32 page image

ERQ12-U4R2 & ERQ12-F2R2 Serial ATA Disk Array Systems232 Basic Configuration – Mounting in a RackMounting in a RackWhen the disk array system is completely set up, it can be installed in a standard 19-inch rack.Follow the instructions in this section to install the disk array system in a rack.1 Clip eight rack nuts supplied with your rack, into the rack, taking care that they corre-spond with the mounting points on the rails.2 Extend both of the rails so that they are the right length to fit in your rack.3 Bolt the rails into the rack using the rack bolts supplied with your rack.You will need four nuts and bolts (not included) for each rail; two at the front and twoat the back.4 Tighten the locking screws when they are the correct length.5 Slide the disk array system into the rack and bolt it into place with the supplied fixingscrews.CautionThis product is heavy. Attempting to install the disk array system in a rackby yourself could result in injury or damage to the product.